BOLT2412 - Bennett Marine Bennett BOLT2412 Electric Trim Tabs 24X12 Require Control

Bennett 24X12 Trim Tab System

Bennett Electric Trim Tab Sets without Controls

• Wires are concealed and protected through the upper hinge - there are no exposed wires to the marine environment
• Robust, water-tight black nylon actuator provides trouble-free operation
• Main seal located high to protect against marine growth and water intrusion failures
• Quieter than any other system on the market - No more scaring the fish away!
• Installation is fast - no need to disassemble parts of the actuator

Boaters can now enjoy a durable and reliable electric trim tab system designed for 17-28 foot boats.

Bennett Marine invented the electric trim tab in 1960 and now Bennett leads the way with a brand new electric trim tab system designed to outperform and outlast any electric system on the market.

Compared to other electric systems using old technologies designed over twenty years ago, the BOLT Electric combines cutting-edge technology with a robust and water-tight actuator. This new "Superior by Design" technology resolves the issues that older systems have with breaking apart and water intrusion caused by design flaws and marine growth.

While Bennett strongly recommends hydraulic trim tabs for most applications, electric trim tab systems are suitable for:

• Trailered boats from 17-28 feet
• Single actuator use, due to the inability to synchronize two electric actuators on the same tab

Requires one of the following controls to complete the system.

• BRC4000 - Bolt Rocker Switch
• BCN6000 - Bolt Control - Non Indicator
• BCI8000 - Bolt Control - With Indicator

• 12-volt actuators (2) with 6ft. wire harnesses and waterproof connectors
• Stainless steel trim planes (2) and mounting plates
• 20 Ft Wire Harness with waterproof connectors

The Bennett BOLT2412 Electric Trim Tab system provides a durable and reliable solution for marine vessel stabilization. This system is designed for trailered boats ranging from 17 to 28 feet in length. It includes two 12-volt actuators with 6ft wire harnesses, two stainless steel trim planes, mounting plates, and a 20ft wire harness with waterproof connectors. The actuators feature concealed wiring within the upper hinge, protecting them from the marine environment, and a robust, water-tight black nylon construction. The main seal is positioned high to mitigate issues related to marine growth and water intrusion. This system is suitable for single actuator use on a tab, as synchronization of multiple electric actuators on the same tab is not supported. It requires a separate control unit, such as the BRC4000, BCN6000, or BCI8000, to complete the installation and operation.