Spi Atx 300pa B204 300w Atx V22 204pin 8cm Ball Bearing Fan 1sata ATX-300PA-B204

Rated: 5.00 of 1 Total Vote
In Stock 16
Suggested Retail $ 55.04
Price: $ 44.03
1 Year Replacementadd $ 5.99
2 Year Replacementadd $ 11.99
1 Year Replacement with Accidentaladd $ 14.99
2 Year Replacement with Accidentaladd $ 24.99
No Product Replacement Plan
AZTEK SKU #: 2395931
Condition: NEW
Email Page

SPI ATX-300PA-B204 300W ATX V2.2 20+4PIN 8CM Ball-bearing FAN 1SATA

300 Watts ATX12V-2.2 Switching Power Supply

Vendor:Sparkle Power Inc.
Key Features
Output Power - 300 W
Warranty - 1 Year
MTBF - 100,000 Hours
Dimensions WxDxH - 6" x 5.5" x 3.4"
Connectors - 20+4-pin,12V 4-pin, 4xPeripheral 4-pin, 1xFloppy 4-pin , 1xS-ATA 5-pin
Form Factor - ATX 12V 2.2
AC Input - 115V/230V
Fan Features - 80mm ball bearing fan
Weight - 3.7 lbs
Detail Specifications
Mfr Part Number: ATX-300PA-B204
Complied with ATX12V 2.0 standard
High efficiency, low noise and ripple and reliability
Remote On/Off function
Internal 80mm 12V DC fan included
Noise Killer (Thermal fan speed control function)
Complies with FCC part 15 subpart J Class B and CISPR 22 Class B
Output over voltage, short circuit, and over current protection
100% Hi-pot, ATE, and burn-in tested
Re-settable power shut down
Approved by UL 60950, TUV, IEC 60950, NEMKO (CB Report)
Included On/Off Switch
Input Range: +/-10% of 115Vrms/57- 63Hz, +/-10% of 230Vrms/47- 53Hz, manual selection.
Input Current: 7A (RMS) at 115Vrms/60Hz, 4A (RMS) at 230Vrms/50Hz
Inrush Current: 80A Max cold start, 100A Max warm start measured at 115Vrms/60Hz
Total Output: 300W
+3.3V and +5V total output not exceed 120W
+3.3V is load on 20A then +5V maximum load is 10.8A +5V is load on 20A then +3.3V maximum load is 6A
+12V1+12V2 total output not exceed 264W
+3.3V, +5V, +12V1, and +12V2 total output not exceed 286W
Connectors: 20/24pin Main power, 4pin P4 power, 4x Peripheral, 1x SATA, 1x Floppy
Dielectric Withstand: Input to frame ground 1800V AC for 1 second
Insulation Resistance: 20 Meg. Ohm Min.
Efficiency: 70% minimum measured at nominal AC main voltage with maximum load on all outputs
Rise Time: Less than 20mS on all outputs
Hold-up Time: 12ms minimum at 115V/230VAC
Power Good Signal: Power on delay time 100 ms to 500 ms, off delay 1ms minimum (TTL and CMOS compatible)
Leakage Current: Not exceed 3.5mA
MTBF:100,000 hours on maximum load at +25C
Dimension (WxLxH): 6 x 5.5 x 3.4 inch / 150 x 140 x 86 mm
Warranty: 1 Year
Processing time: 0.3077 seconds